Similar
NASA NOISE SUPPRESSOR COWLING - Glenn Research Center History
Production. B-25 "Billy Mitchell" bombers. A landing gear ready for assembly on a B-25 bomber is rolled into place on the final assembly line of North American's Inglewood, California, plant. In addition to the battle-tested B-25 "Billy Mitchell" bomber, in General Doolittle's raid on Tokyo, this plant produces the P-51 "Mustang" fighter plane which was first brought into prominence by the British raid on Dieppe
Production. B-25 "Billy Mitchell" bombers. A landing gear ready for assembly on a B-25 bomber is rolled into place on the final assembly line of North American's Inglewood, California, plant. In addition to the battle-tested B-25 "Billy Mitchell" bomber, in General Doolittle's raid on Tokyo, this plant produces the P-51 "Mustang" fighter plane which was first brought into prominence by the British raid on Dieppe
Staff Sgt. Mark Blinn, 96th Aircraft Maintenance Squadron
NORTHROP GRUMMAN - HERSH ACTIVE & PASSIVE NOISE CONTROL ON THE NASA 4 F. LOW SPEED FAN
KENNEDY SPACE CENTER, FLA. -- In Orbiter Processing Facility bay 3, United Space Alliance and B.F. Goodrich technicians begin work on the starboard landing gear assembly of space shuttle Discovery. They will replace a leaking dynamic seal in Discovery's right main-gear strut. The struts act as shock absorbers during the shuttle's landing. Engineers determined the observed leak of hydraulic fluid in the main landing gear strut exceeded specification and could not be reduced to an acceptable rate. Removing the strut and replacing seals require disconnecting and replacing the brakes and tires, disconnecting and reconnecting instruments and other requirements to allow access to the strut. Discovery had been scheduled to roll over Sept. 19 from its processing hangar to the Vehicle Assembly Building. A new rollover date will be set after technicians determine how long replacing the seal will take. Photo credit: NASA/George Shelton KSC-07pd2491
HEAT EXCHANGER, NASA Technology Images
JOURNAL BEARINGS RUB MARKS - HYDRAULIC BEARING SURFACE RUBBING
HIGH SPEED FAN HARDWARE FOR 9X15 FOOT WIND TUNNEL TEST
Related
4 JOURNAL BEARINGS SHOWING DAMAGED INNER DIAMETERS ID
4 JOURNAL BEARINGS SHOWING DAMAGED INNER DIAMETERS ID
4 JOURNAL BEARINGS SHOWING DAMAGED INNER DIAMETERS ID
4 MIDPARK HIGH SCHOOL STUDENTS PARTCIPATING IN SECRETARY FOR A DAY
4 MIDPARK HIGH SCHOOL STUDENTS PARTCIPATING IN SECRETARY FOR A DAY
NO. 4 BOILER LOCATED AT THE STEAM PLANT
4 MIDPARK HIGH SCHOOL STUDENTS PARTCIPATING IN SECRETARY FOR A DAY
4 POINT BEND TEST SETUP WITH PISTON CYLINDER DEFLECTOMETER
4 MIDPARK HIGH SCHOOL STUDENTS PARTCIPATING IN SECRETARY FOR A DAY
4 JOURNAL BEARINGS SHOWING DAMAGED INNER DIAMETERS ID
Summary
The original finding aid described this as:
Capture Date: 1/29/1974
Photographer: PAUL RIEDEL
Keywords: Larsen Scan
Photographs Relating to Agency Activities, Facilities and Personnel
Nothing Found.
Tags
journal
bearings
journal bearings
inner
diameters
nasa
national aeronautics and space administration
high resolution
ultra high resolution
inner diameters
photographer
paul riedel
nasa photographs
1970 s
space program
us national archives
Date
1974
Source
The U.S. National Archives
Link
Copyright info
No known copyright restrictions